Home What's New Building the Daylight Daylight Tender Observation Car Engine Stand Gondolas Gauge Bell Ringer Air Compressor Gas Switcher

#42 Turbulators

Back Next

Twist and Shout!

Got some 5/8" stainless steel role for the 32 turbulators that were needed.  First step was to cut them to length.

 

Then I set up the lathe to help twist them...

 

Here they are all done

 

And finally installed

 

Here's the arch installed

Back Next

#01 So It Began #2 Frame #3 Drivers #4 Quartering #5 Trucks #6 Frame & Wheels #7 Side Rods #8 Cylinder Boring #9 Cyl/Valve Liners #10 Cyl/Valve Cover #11 Pistons & Valves #12 Cyl Assembled #13 Boiler #14 Suspension #15 Crosshead #16 Brakes #17 Link Support #18 Bell #19 Crosshead (again) #20 Connecting Rod #21 Stationary Runner #22 Smokebox #23 Valve Gear #24 Running on Air #25 Piston Rings #26 Axle Pump #27 Plating #28 Lubrication #29 Blast Nozzle #30 Stack #31 Steam Turret #32 Burner Manifold #33 Mounting Brackets #34 Boiler Insulation #35 Jacketing #36 Cab #37 Throttle #38 Reverse Lever #39 Track Test #40 Smokebox Access #41 Electric Blower #42 Turbulators #43 Burner Test #44 Piping #45 Cab (part 2) #46 Inaugural Run #47 Post Steamup #48 Smokebox Lights #49 Running Boards #50 Pilot #51 Skirting #52 Paint #53 Lettering #54 Whistle #55 Skyline Casing #56 Fuel System Mods #57 Odds and Ends #58 Turbos

Home | What's New | Building the Daylight | Daylight Tender | Observation Car | Engine Stand | Gondolas | Gauge | Bell Ringer | Air Compressor | Gas Switcher

 

 

Questions or problems regarding this web site should be directed to [heydan "at" danslocoworks "dot" com].
Copyright 2016, 2017 [Dan's Loco Works]. All rights reserved.
Last modified: 09/02/2017.